Development and characterization of edible cups made from wheat, sorghum, and coffee pulp flour
DOI:
https://doi.org/10.25186/.v20i.2378Abstract
The use of plastic containers is increasing enormously, raising concerns about their improper disposal and their contribution to environmental pollution. The study aimed to develop and characterize edible cups made with wheat and sorghum flour, incorporating coffee pulp flour into their formulation. Percentages used of these flours in the three treatments studied were T1: 50-38-2 %; T2: 40-45-5 %; and T3: 30-52-8 %, respectively, and 10 % of cornstarch in all of them. Color, hardness, water absorption capacity, liquid resistance (distilled water at 20-25 and 75-80 °C), biodegradability, and fiber and protein analysis of the obtained containers were analyzed. Both one-way analysis of variance and the Tukey mean test were done at p˂0.05. The results, in comparison with a commercial edible cup, showed an acceptable cup color and a high protein (~11.8 %) and fiber (~3.62 %) content; hardness values (~37N for T1 and T2 and ~42N for T3) were lower. T2-T3 exhibited the low water absorption capacity and liquid resistance at 25°C (~28% at 30 min and ~165 min
at 25°C, respectively), while T2 and T3 had the high-water stability at 80°C (~110 min). The developed edible cups exhibited the high biodegradability rate (~63%), decomposing in ~12 days. Including coffee pulp flour as an ingredient in the manufacture of edible cups allows obtaining containers with good structural integrity and physical properties superior to those of commercially available edible containers.
Key words: Comestible mugs; physical properties; biodegradable; coffee husk.
References
ANAND, K. et al. A tasty solution to packaging waste? Life cycle assessment of edible coffee cups. Resources, Conservation and Recycling, 201:107320, 2024.
ANANDA, G. K. S. et al. Wild sorghum as a promising resource for crop improvement. Frontiers in Plant Science, 11:1108, 2020.
ASSOCIATION OF OFFICIAL ANALYTICAL COLLABORATION - AOAC. Official method of Analysis. 18th Edition, Association of Officiating Analytical Chemists, Washington DC, Method 925.10 and 962.09, 2005.
ARTEAGA, M. N. et al. Isolation and identification of a native microbial consortium for the coffee pulp degradation above 2000 masl. Coffee Science, 16:e161810, 2021.
BLUMENTHAL, P. et al. Production of coffee cherry spirits from coffea arabica varieties. Foods, 11(12):1-28, 2022.
CHOEYBUNDIT, W. et al. Fabrication of edible and biodegradable cutlery from morning glory (Ipomoea aquatic) stem fiber-reinforced onto soy protein isolate. Heliyon, 8(5):e09529, 2022.
DORDEVIC, D. et al. Plastic cutlery alternative: Case study with biodegradable spoons. Foods, 10(7):1612, 2021.
GEMECHU, F. Embracing nutritional qualities, biological activities and technological properties of coffee byproducts in functional food formulation. Trends in Food Science & Technology, 104:235-261, 2020.
GIL-RAMÍREZ, A. et al. Unveiling the nutritional profile and safety of coffee pulp as a first step in its valorization strategy. Foods, 13(18):3006, 2024.
HABLA, F. A. et al. Development of non-wheat edible spoon. Sorsogon Multidisciplinary Research Journal, 1(1):1-12, 2023.
HAZRA, S.; SONTAKKE, M. Process development and quality evaluation edible cutlery spoons supplemented with Withania somnifera root powder. The Pharma Innovation Journal, 12(5):1874-1883, 2023.
INTERNATIONAL COFFEE ORGANIZATION - ICO. Coffee report and outlook international coffee organization. 2023. Available in: <https://icocoffee.org/documents/cy2023-24/Coffee_Report_and_Outlook_December_2023_ICO.pdf>. Access in: September 4, 2025.
KABIR, M. H.; HAMIDON, N. A Study of edible cutleries by using sorghum flour. Progress in Engineering Application and Technology, 2(1):292-300, 2021.
KIGOZI, J. et al. Optimization of texture in sorghum Ice Cream cone production using sensory analysis. The Open Food Science Journal, 8:18-21, 2014.
KIGOZI, J. et al. Sorghum ice cream cone texture; correlations between intrumental and sensory analysis. Journal of Advances in Food Science and Technology, 3(3):134-145, 2016.
KLINGEL, T. et al. A review of coffee by-products including leaf, flower, cherry, husk, silver skin, and spent grounds as novel foods within the European Union. Foods, 9(5):1-20, 2020.
LIU, C. et al. Biodegradable, hygienic, and compostable tableware from hybrid sugarcane and bamboo fibers as plastic alternative. Matter, 3(6):2066-2079, 2020.
MAKAROVA, N. V.; EREMEEVA, N. B. Research of properties of edible packaging based on apple puree with addition of dried fruit and vegetable raw materials. Innovations and Food Safety, 1:14-24, 2021.
MISHRA, V. K.; SINGH, N.; NANDA, A. Nutritional & Antimicrobial Analysis of Developed Edible Basket Using Nori Sheet. European Journal of Nutrition & Food Safety, 16(1):38-51, 2024.
NEHRA, A.; BISWAR, D.; ROY, S. Fabrication of brewer’s spent grain fortified bio-based edible bowls: a promising alternative to plastic containers. Biomass Conversion and Biorefinery, 14:16425-16434, 2022.
OLEA, N.; SALAMANCA-FERNÁNDEZ, E.; DOMINGO, P.; FERNANDEZ, M. ¿Por qué el plástico es una amenaza para la salud? Granada: [s.n.]. Disponível em: https://microservices.es/storage/3620/Plasticos-ciudadania_06.pdf, 2023.
RAJENDRAN, S. P. et al. Optimization of composition for preparation of edible cutlery using response surface methodology (RSM). AIP Conference Proceedings, 2240:050001, 2020.
RAMMYA, K. et al. Standardization and quality evaluation of wheat flour based edible tableware. The Journal of Research ANGRAU, 52(1):94-102, 2024.
SENTHILKUMAR, P. et al. Formulation and quality assessment of biodegradable edible cutlery with banana and quinoa integration. SSRN, 2024.
SHULGA, O. et al. Consumer properties of biodegradable edible cups for hot drinks. Ukrainian Food Journal, 12(3):336-351, 2023.
SIDDIQUI, B. et al. Exploring the potential of mosambi peel and sago powder in developing edible spoons. Sustainable Food Technology, 1(6):921-929, 2023.
SIMANTIRIS, N. Single-use plastic or paper products? A dilemma that requires societal change. Cleaner Waste Systems, 7:100128, 2024.
SINDHU, K.; SWAMY, R.; PRASHANTHI, M. Enrichment of edible spoons with natural colours. The Pharma Innovation Journal, 12(5):4259-4263, 2023.
SOOD, S.; DEEPSHIKHA. Development and quality evaluation of edible plate. ARC Journal of Nutrition and Drowth, 4(2):1-4, 2018.
STUTI, J.; VIRGINIA, P. “Development and standardisation of edible bowls by utilization of citrus peel and pulp”. International Journal of Research in Engineering and Science (IJRES), 10(9):502-504, 2022.
TAKO, M. et al. The principles of starch gelatinization and retrogradation. Food and Nutrition Sciences, 5(3):280-291, 2014.
THAGUNNA, B. et al. Development and quality evaluation of biodegradable edible cutlery: a replacement for a conventional one. Asian Journal of Pharmaceutical and Clinical Research, 16(2):49-52, 2023.
TORRES-VALENZUELA, L. S. et al. Drying of coffee pulp: Process parameters, mathematical model and its effect over physicochemical properties. Informacion Tecnologica, 30(2):189-200, 2019.
UDACHAN, I. S.; SAHOO, A. K.; HEND, G. M. Extraction and characterization of sorghum (sorghum bicolor L. moench) starch. International Food Research Journal, 19(1):315-319, 2012.
VISWANATHAN, K.; PASUPATHY, B. Studies on piston bowl geometries using single blend ratio of various non-edible oils. Environmental Science and Pollution Research International, 24(20):17068-17080, 2017.
WULANDARI, T. D. et al. Characteristics of edible bowls made from papaya skin as an effort to tackle plastic Waste in Indonesia. Journal of Environmental and Science Education, 3(2):119-126, 2023.
YODKUM, T.; PAJAREON, S.; YOKESAHACHART, C. Effect of defatted rice bran content on physicochemical and sensory properties of edible cutlery made from rice flour green composites using compression molding. Journal of Current Science and Technology, 14(3):Article 62, 2024.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2025 Coffee Science - ISSN 1984-3909The copyright of the articles published in this journal belongs to the authors, with the journal holding the first publication rights. As the articles are published in this journal under open access, they may be freely used, with proper attribution, for educational and non-commercial purposes
